RS PRO End Mill, 5mm Cutter, HSCo, 6 Mm Shank, 7.5mm Cut

Epson, 20MHz XO Oscillator, ±50ppm CMOS, 4-Pin SMD Q3309CA40000401, Mounting Type: Surface Mount, Minimum Operating Temperature: -20°C, Height: 1.

5 → 24 V dc, Terminal Type: Wire Lead, Switching Current: 250 mA, Length: 32mm, Width: 24mm, Depth: 10mm, Dimensions: 32 x 24 x 10 mm, IP Rating: IP65, Maximum Operating Temperature: +60°C, Housing Material: ABS, Minimum Operating Temperature: -10°C, Standards Met: RoHS.RS PRO Hall Effect Sensor, Open Collector PNP + NPN Output Output, 7.

SKF 7208 BEP Single Row Angular Contact Ball Bearing- Open Type End Type, 40mm I.5kN, Bore Type: Parallel, Bearing Series: 2 Light.D, 80mm O.D, Race Width: 18mm, Bearing Clearance: CN, Material: Steel, Cage Material: Non-metallic, Static Load Rating: 24kN, Dynamic Load Rating: 34.

6mm, Bearing Clearance: CN, Material: Steel, Cage Material: Non-metallic, Static Load Rating: 12.9kN, Dynamic Load Rating: 20.

D, Race Width: 15mm, Bore Type: Parallel, Material: Steel, Static Load Rating: 27kN, Cage Material: Fibreglass Reinforced PA, Dynamic Load Rating: 32.5kN, End Type: Open, Limiting Speed: 16000rpm, Reference Speed: 15000rpm, Fatigue Limit Load: 3.

8mm.RS PRO C60 VDE/1000V Insulated Side Cutters, Overall Length: 180 mm, VDE/1000V Approved: Yes, Maximum Cutting Capacity: 3.

6bar Bottom Entry, 0bar min.50, Gauge Outside Diameter: 63mm, Pressure Gauge Type: Dial, MPN: 9020721.

5mm Cut, Overall Length: 36 mm, Shank Type: Weldon.RS PRO End Mill, 5mm Cutter, HSCo, 6 mm Shank, 7.

WIKA G 1/4 Analogue Analogue Positive Pressure Gauge 1.6bar Bottom Entry, 0bar min.

RS PRO End Mill, 5mm Cutter, HSCo, 6 mm Shank, 7.5mm Cut, Overall Length: 36 mm, Shank Type: Weldon.